A sneak peak into our Primer Booth.
We also have 2 8x8x27ft batch ovens.
Dci Metal Finishing Powder Coated Products:
The final Step is a very important step to the finish coat.
The powder is held on to the part by static electricity.
Once coated, the parts are baked at 375 to 415 Fahrenheit.
The curing oven melts the dry powder to a "gel state" and then further curing causes this gel to harden into a very tough "plastic" coating.
This flowing and fusing of the coating in the final curing oven creates a continuous coating which is very hard and hasno porosity.
Our 80ft Main oven.
We Proudly Serve The Following Industries
Sometimes parts need a little TLC before we powder coating them.
That is where our Sandblast room comes in play.
It takes a strong company to outshine the others.
Inside and outside perspective of our 35ft Sandblast room.
Each part gets the necessary cleaning. A look in our 5 stage wash.
Our Main booth hard at work.
Our Gel Oven.
After pre- cleaning the parts travel through a dry off oven to remove excess water. Parts enter a primer booth where zinc and non`zinc primer can be applied
The first and most important step to powder coating is the pretreatment. DCI uses Zirconium phosphate which is an iron rich conversion coating. This will give your parts the best corrosion resistance steel or aluminium
DCI Powder Coating
Professional Metal Finishing Company